What is the process of using the biodegradable plastic extruder?

The biodegradable plastic extruder offers numerous benefits in the agricultural sector. For example, in the pharmaceutical industry, some packaging products made by biodegradable plastic extruder can not only ensure the safety of pharmaceutical ingredients but also greatly reduce packaging costs.

• What is the process of using the biodegradable plastic extruder?

• What are the prospects for the use of biodegradable plastic extruder?

• What is the operating procedure for the biodegradable plastic extruder?

What is the process of using the biodegradable plastic extruder?

To use the biodegradable plastic extruder, first prepare the plastic to be degraded. Then put these plastics into the machine, turn on the heating switch, and let the temperature rise to the desired temperature. Generally speaking, if you want to degrade large pieces of plastic, the temperature required will be higher. For small pieces of plastic, the required temperature will be relatively lower. While heating, the rotating fan can also be properly turned on according to the actual situation to speed up the heat dissipation.

What are the prospects for the use of biodegradable plastic extruder?

When the biodegradable plastic extruder is heated to the required temperature, the cyclone fan can be properly turned on to speed up the heat dissipation. After the rotating fan completely dissipates the heat, the heating switch can be turned off and the degraded plastic sheet can be taken out. Degradable plastic granulator is a new type of plastic processing equipment, which can decompose plastic waste into particles, and can further process these particles into new plastic products. At present, biodegradable plastic extruder has been widely used around the world, and has achieved good economic and social benefits.

What is the operating procedure for the biodegradable plastic extruder?

(1) Check the rotation direction of the impeller. From the feed port, the impeller should be turned counterclockwise, otherwise the wiring of the motor should be adjusted.

(2) The starting sequence of the crusher and material conveying equipment is as follows:

Discharge port belt conveyor → PL vertical impact crusher → feeding belt conveyor

The crusher must be started with no load, and the material can be fed only after the crusher runs normally.

(3) The feed particle size of the biodegradable plastic extruder is strictly in accordance with the feed particle size specified by various models. It is forbidden to enter the crusher with a material size larger than the specified size, otherwise it will cause imbalance of the impeller and excessive wear of the impeller, and even cause blockage of the blades The alternate channel and the central feeding pipe prevent the crusher from working normally. When large pieces of material are found, they should be removed in time.

(4) When the discharge belt conveyor stops running, the feeding should be stopped immediately, so the discharge belt conveyor should be interlocked with the feeding system to open and stop. Otherwise, the impeller will be crushed and the motor will be burned.

(5) The feeding should be uniform and continuous.

(6) During the operation of the biodegradable plastic extruder, there must be no violent vibration and abnormal noise, otherwise, it should be stopped immediately for inspection, and the drive can be started in sequence after the fault is eliminated.

(7) The observation door of the biodegradable plastic extruder should be tightly sealed during the working process.

For more information about iodegradable plastic extruder, please contact Nanjing Haisi Extrusion Equipment Co., Ltd. has committed to providing the increasing of iodegradable plastic extruder, and make them more effective, reliable, and consistent.